Falcon reset glitch hangs on glitching

You can ask/talk about the Reset Glitch Hack in general
Post Reply
djblade17

Falcon reset glitch hangs on glitching

Post by djblade17 » Sun Oct 23, 2011 2:55 pm

30-1 minute it takes to glitch my consoles or it wont even glitch at all
dash 13146 the one where only 1 ldv is there the other is blank(dont know if this matters)
Stock Matrix glitcher
I have 2 other falcons that glitch fine
I am using a alternate b points( the one thats used for post readout) I ripped my first one I think
Altho i can get the wire to stick there no problem I thought this would be my issues so I tested the alt and the same thing

I am using gliglig 1.1 build with falcon support
1/5 times it will succeed
If i build with *** it wont work at all sits there blinking center light then eventually goes to rrod
Comments suggestions?

For creating gg build i needed to use flash360 to extract the extra files needed
While on the first 2 falcons i did not need too


I also have a usb uart  ttl cable if needed?
Last edited by djblade17 on Sun Oct 23, 2011 3:46 pm, edited 1 time in total.

djblade17

Re: Falcon reset glitch hangs on glitching

Post by djblade17 » Sun Oct 23, 2011 10:09 pm

Redid wiring and software
seems to glitch a lot better  kernal booting
but seems to be slower then my others

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest