Falcon RGH Issue - Won't boot

You can ask/talk about the Reset Glitch Hack in general
Wabby

Falcon RGH Issue - Won't boot

Postby Wabby » Sat Nov 12, 2011 9:30 am

Hi,

Just finished wiring up my falcon, and it wont boot. It just sits there with the green power light on.
I can hear the fans change speed every so often, so I assume the CPLD is trying to do the RGH?

I so far have done the following:

  • Reflashed the CPLD with the JED file within the v1.1 folder
  • Checked all wiring and its fine (I am, however, using 30AWG Kynar wire for all connections, is this ok?)
  • Tried changing the 1k resistor for a 10k resistor
  • Tried re-flashing the ecc to the nand, again

Does anybody have any suggestions so that I can get this baby booting?

Ta

Wabby

Re: Falcon RGH Issue - Won't boot

Postby Wabby » Sat Nov 12, 2011 9:53 am

I have also just tried taking 1.8v straight from the mobo - still no glitchy.

xb0xguru

Re: Falcon RGH Issue - Won't boot

Postby xb0xguru » Sat Nov 12, 2011 12:17 pm

What CB values do you have in 360 Flash Dump Tool?

spandaman

Falcon RGH Issue - Won't boot

Postby spandaman » Sat Nov 12, 2011 12:43 pm

I would use thicker wire for vcc and ground, how long have you waited for it to boot?


Sent from my iPhone using Tapatalk

Wabby

Re: Falcon RGH Issue - Won't boot

Postby Wabby » Sat Nov 12, 2011 8:08 pm

2BL (CB) = 5771
4BL (CD) = 8453
5BL (CE) = 1888

Also, in 360 Flash Dump Tool is says bad Key/KV and a bad block @ 00D5 and 0173.

Do I need to remap block 00D5 from eee.bin to 3FF?

User avatar
Cancerous1
Administrator
Administrator
Posts: 88
Joined: Sat Feb 19, 2011 5:25 pm

Re: Falcon RGH Issue - Won't boot

Postby Cancerous1 » Sat Nov 12, 2011 8:20 pm

use a thicker ground/power than kynar

Wabby

Re: Falcon RGH Issue - Won't boot

Postby Wabby » Sat Nov 12, 2011 9:05 pm

Just tried that - Still wont boot.

How do I remap the bad block @ 04D so that the .ecc file will write properly and then Xell should boot?

Wabby

Re: Falcon RGH Issue - Won't boot

Postby Wabby » Sun Nov 13, 2011 10:32 am

Got it working.

For some reason I de-soldered 3.3v when soldering 1.8v - what a n00b!

Took it off in a rampage, and noticed it wasnt soldered! lol

xB32

Re: Falcon RGH Issue - Won't boot

Postby xB32 » Sun Dec 11, 2011 1:28 am

I have had similar problems as you, please could you tell me the current variables under which your Falcon RGH is working?


Return to “Reset Glitch Hack”

Who is online

Users browsing this forum: No registered users and 1 guest